View Full Version : Aveox motor bearings
06-20-2004, 01:48 PM
I've just gotten a Aveox 1050/2Y motor but i noticed that the front bearing is worn out. Can someone tell me if it is difficult to replace it? I mean how to open the motor and replacing the front bearing.
Thanks a bunch,
06-21-2004, 03:51 PM
The endbells are just ca'ed on.Tap the shaft down on a wooden table to get the endbell off. The bearings sometimes are glued in as well with loctite but not a big deal to push them out.When putting the motor back together be sure to use a little thin ca on the endbell to hold it back together.
06-21-2004, 11:50 PM
Will try that tonight when i come home from work. I wasn't sure, but so they are "sealed" like most motors then.
Thanks for clearing that out.
Did you remeber of me? Jérôme from northern France.
(we talked about 400 boat last year...)
Just a post without link with the subject, to know if you race in Belgium during summer hollydays?
I still have the same email : jdegand(a)free.fr
vBulletin® v3.8.6, Copyright ©2000-2013, Jelsoft Enterprises Ltd.