AndyKunz - AVL Hull

[AndyKunz]

Well, I'm in for the Moderators Challenge. I'll be doing an AVL hull with Caleb doing the round nose. Just sent my order to Paul a minute ago. My paint job is TBD, but definitely non-scale.

The powerplant will be the same as Trent used to wax some N2 riggers.

Andy

[AndyKunz]

I started cutting parts out tonight. Finally.

Photos will be coming soon.

The laser cutting on my hull was far superior to what Caleb's round-nose was, but the wood quality was just as low. While both were made from rather hard wood, mine was not even even thicknesses. I have pieces of '3/32"' that ranges from .090 to .109 (it should be .093). Hopefully Paul will watch both wood and laser cutting quality a little closer in the future.

Andy