Esc ???

[Pooley929]

Guys I got this esc used and I don't use these kind of connectors I use deans so I need to change them the problem is I don't know where the batt goes and the motor........... I think the batt may go where the small wire goes for the on off switch if you guys can help that will be great :(

[Dick Crowe]

Check your e-mail, I've got you covered!

See ya,
Dick

[Ray Bidwell]

Dick why not post the answer others might be currios also. My thinking is that the batteries go on the red and black would I have blown it.

[Dick Crowe]

Sorry Ray,
No secrets, he had asked Ray Fuller and Ray forwarded the e-mail to me. I answered it a couple days ago but accidentally replied to Ray, not Louis. Anyway, I finally figured it out and re-sent it to him.
BTW, Blue wire always goes to the motor Negative (on a brushed controller). Black goes to the batt neg and the red's are motor/batt pos.

See ya,
Dick

[JfromJAGs]

Dick, if this is right it would make more sense to connect the thin black wire (switched BEC plus) to the side of the black negative.

Anyway a pretty dangerous setup. It's very easy to connect the batteries to the wrong side.

BTW, this setup needs a Schottky diode installed on the motor.

Joerg

[Pooley929]

Do I need a schotty on there or is it ok without

[Dick Crowe]

A shotkey is always a good idea. I'll send some with the extra G plugs.
See ya,
Dick