PDA

View Full Version : Clearence Sale, Brushless Motor And More


roostercone
06-06-2008, 06:38 PM
Brushless and Brushed stuff i have to get rid of.
you pay shipping
I take US money orders
and Pay Pal

Brushed first:
Basically a Aquacraft electric Hammer Kit....
Transmitter,RX,and Servo (no crystals)$30
ESC$25
props and flex shaft, rudder $25
550 motor no coupler $10
550 motor unremovable part coupler $5
i'll take $60 for all this and throw in two 380 motors with motor mounts

BJ Outdrive drive with prop, arm and turn fins $30
note: I used this on a 22" plastic mono and it worked great, very responsive turning.

Brushless stuff
BJ motor (less that ten runs)comes with cooling and coupler $50
Brand new BJ transmitter & receiver no crystals $30
Used RX no crystal $10

My bro said he will buy my flash but if you make an offer on it i will let it go(My loss) the bids start at $70 bare hull cleaned with hardware.
All orders will be shipped on a Wednesday.

Thanks Everyone

The flash is a low and suprisingly it self righting. I have brought it in evey time it flipped with out a rescue boat. Picture update This boat has a prop scratch on the rudder (not major), A extra hole at the rear for a servo arm(now sealed) one antenna hole on the stern, antenna now moved to the rear. Tiny nics and unoticeable scratches. The spot seen in side is where i used a lil gorilla glue to mount servo to avoid drilling holes. This is the hull cleaned and ready

tekajo
06-11-2008, 10:20 PM
Can you run a 540 brushless with the flash?

roostercone
06-13-2008, 06:10 PM
Its possible but it wount get you the performance of a brushless system. The 540 i have is a good motor but its under powered for this ESC, and higher amp esc with 14.4 volts will get this flash flying. it doesnt take much to get it going though the stepped hull makes it plane and accelerate.

roostercone
06-13-2008, 06:24 PM
http://youtube.com/watch?v=n0qU96bGLZ8 this is the flash runing with a BJ system 12cell 14.4volts

roostercone
07-04-2008, 05:10 PM
All things here have been sold thanks for viewing