Anyone have any ideas for an adjustable motor mount...

[SORCERER002]

I'm trying to figure out a way to make an adjustable motor mount for my Systems. I'm installing the Fine Design Cordite 820 (?), and I want to be able to adjust the angle of the motor. I'd also like to be able to remove the whole mount in order to perform maintenance on the motor (If it ever would need any). I may be asking for too much, especially considering I'd like to keep the weight down.
Anyone have some plans, or sell what I'm looking for?

- Brendon

[JimClark]

I hope you will be able to see the in the pic's I have attached. In the first pic you see the basic motor mount with the upright attachments. In the second pic you see the aluminum C shaped mount that is attached to the two uprights by the pins in the black connectors. This gives movement up and down and also it can slide fore and aft as there is a slot in the side of the part attached to the motor.
Hope this helps.
Jim Clark

[JimClark]

Here is the second picture

[Dan Chase]

Jim's mount is SUPER slick! Especially if your running a straight shaft!

[jtnrumrunner]

Hobby-Lobby has this <a href = "http://www.hobby-lobby.com/scaledrives.htm">tiltable motor mount</a> made by Graupner. Haven't used it myself, but was considering getting one.