After watching the OPC and 10th Scale a the MCX Nat's, I'm going into another build mode. What better spot is the new Blog.
So as things progress I'll show off what I'm doing..... :thumup:
So as things progress I'll show off what I'm doing..... :thumup:
-
Gale v
I noticed, just didnt know what I was lookin at.
I did wonder why you didnt make the part out of ply?
T.C.Posted 11-13-2009 at 10:26 AM by T.C. 
-
Gale v
The flood chamber is not a hole, but glad you asked. The secret is to drill a 1 1/4" hole and use the canister that you get 35mm film in. only 1 1/2 " deep no leakage. After glassing over and trimming I'll put the cross bar in.
Good question though..... Thanks for watching the buildPosted 11-12-2009 at 02:44 PM by chuckc
-
Posted 11-12-2009 at 02:32 PM by T.C.
-
Posted 10-29-2009 at 08:58 PM by john p gross
-
Gale iv
Gale IV
After comparing dimension's The Gale IV is now going to be the GALE V Version III built for the 1958 Season after the Gale V Version II was scrapped in 1957. This hull ran the circuit from 1958 thru 1964.
Reason: hull length; Gale IV was 29 ft and the Gale V v-III was 30.6"
I intend to run this boat with no engine cowling as she did in most races in Detroit
Posted 10-29-2009 at 09:23 AM by chuckc
Updated 10-29-2009 at 11:46 AM by chuckc -
Posted 10-24-2009 at 11:30 AM by chuckc
-
10th Scale Gale IV Build
I found that many of the parts to big . I know we changed to plywood but, they were way off. RonPosted 10-24-2009 at 07:23 AM by donthavta
